Low Flow Stream Tap Aerator – 3.5l/min
£10.00 inc. VAT
- Perfect solution for small or shallow basins, water saving yet effective.
- 24mm Male & 22mm Female spouts.
This quality monobloc (single spout) 24 & 22mm hand rinse basin stream tap aerator fits both male and female tap threads, as it comes with a metal adaptor, which you can simply unscrew if you don’t need it on your tap.
It’s housed in solid chromed brass (so it won’t rust) and is easy to fit – simply unscrew your existing regulator (found at the end of your tap spout) and screw on this new one – it will be like having a brand new tap! Even expensive & brand new taps can come with cheap & nasty tap ends – so don’t change your whole tap – just change the end of it!
Unscrew your existing regulator which is at the end of your tap spout (you may need to use a tea towel and a pair of pliers to loosen, if your tap end is covered in limescale).
Measure the diameter of the part you’ve removed (at the threading end – the part that sits in or on the tap spout, i.e. not the end where the water comes out) and if it measures 24mm as a Male product (threading on the outside) or 22mm as a Female product (threading on the inside), then this is the product for you! Please note other tap aerator sizes are available.
Now screw the new tap aerator into the tap end (with rubber washer). The product will come with a metal adaptor already screwed onto the tap aerator so if you don’t need it just unscrew it to take off. It will come with a couple of spare rubber washers too. If you’re struggling to achieve a water tight seal, then try wrapping a little PTFE tape around the threading on the tap spout – it’s like thin stretchy plaster and can be picked up for a few pence from a hardware store.
Clean with a damp cloth to remove any scum/lime scale build up. Please do not use abrasive chemicals as they may cause damage.
Parts covered under warranty for 2 years against any manufacturing defects.